Download - Fuji Xerox Printers

Error CodeCause/Remedy116-740 An arithmetic operation error occurred because a value that exceeds the limit for printer print datais used.Check the print data.116-747 The paper margin value is too large for the HP-GL, HP-GL/2 effective coordinate area.Decrease the paper margin values and try printing again.116-748 There is no drawing data in the HP-GL, HP-GL/2 print data.Check the print data.116-749 The job was canceled because the specified font does not exist on the printer.Install the font or use the print driver to specify font conversion.116-750 Banner sheet tray malfunctionRestore the tray to normal condition or change the Banner sheet tray.116-752 The descriptions of the PDF or XPS printing job ticket have a problem.Execute the operation again. If the error still is not resolved, contact our Customer SupportCenter.116-771116-772116-773116-774116-775116-776116-777116-778The data was automatically modified because it included an invalid parameter.Execute the operation again if the print job results have some problem.116-780 There is a problem with the document attached to an e-mail received by the printer.Check the attached document.Refer to• “3.12 Printing Using E-mail - Mail Print -” (P. 103)124-701 The output destination was changed because of the malfunction of the specified output tray (lefttop tray).Contact our Customer Support Center. You can use any output trays other than the defectiveoutput tray.124-702 The output destination was changed because of the malfunction of the specified output tray (rightmiddle tray).Contact our Customer Support Center. You can use any output trays other than the defectiveoutput tray.124-705 The punch setting was cancelled.Confirm the punch position, and then execute the operation again.124-706 The folding setting was cancelled.Confirm the folding setting, and then execute the operation again.124-708 The output destination was changed to the center tray or extra center tray.The probable causes are as follows:1) Paper of a different size from the specified is loaded for 2 sided copying.2) The Punching feature of the Finisher has malfunctioned.Perform the following procedure depending on the cause.For 1), check whether the specified size paper is loaded in the tray.For 2), confirm whether the error code 012-231, 012-232, 012-233, or 012-234 is displayed on thedisplay, and contact our Customer Support Center.124-709 The document exceeded the maximum number of pages that can be stapled.Reduce the number of pages, or cancel the stapling setting, and then try printing again.286 6 Troubleshooting