Download - Fuji Xerox Printers

SettingDescriptionReceivingBuffer- Sets the memory of the receiving buffer (temporary storage locationfor data arriving from the computer) for each interface. Set thespooling setting, allocation location, and size of memory for each ofthe LPD, SMB and IPP interfaces.The receiving buffer size can be changed according to operatingstatus and purpose. Increasing the receiving buffer size sometimesfrees up the computer supporting a particular interface more quickly.The maximum size that can be set changes according to the amountof free memory.Note• When a port is disabled, its corresponding items are not displayed.• Even if the receiving buffer size is increased, the time required tofree up a computer sometimes does not change depending on thesize of data arriving from the computer.Parallel,NetWare, IPP,USB and Port9100EtherTalkCompatLPD Spool,SMB SpoolSpecify memory size from 64 to 1024 KB in 32 KB increments. Thedefault memory size is [64K] for parallel, USB. Otherwise, it is [256K].Note• [IPP] appears when the HDD Extension Kit (optional) is not installed.[IPP Spool] is displayed when the hard disk is installed.• [Parallel] appears only when the Parallel Port Kit (optional) isinstalled.Specify memory size from 1024 to 2048 KB in 32 KB increments. Thedefault is [1024K].• [No Spooling] (default)Spooling is not performed. Data cannot be simultaneously printedand received using the LPD or SMB interfaces.When printing on the LPD interface, set the memory size of thereceiving buffer exclusively for LPD from 1024 to 2048 KB in 32 KBincrements. The default is [1024K].When printing on the SMB interface, set the memory size of thereceiving buffer exclusively for SMB from 64 to 1024 KB in 32 KBincrements. The default is [256K].• [Hard Disk]Spooling to the hard disk is performed. The hard disk is used as thereceiving buffer for spooling. This item appears only when HDDExtension Kit (optional) is installed.• [Memory]Spooling to memory is performed. Memory is used as the receivingbuffer for spooling. When this optional value is selected, set thememory size of the receiving buffer for spooling from 0.5 to32.00 MB in 0.25 MB increments. The default is [1.00M]. Note thatprint data exceeding the preset memory size cannot be received tomemory. In this case, select [Hard Disk] or [No Spooling].Important• When the LPR byte count is disabled and a document larger than thesize set as the spooling memory is received, the job is repeatedlytransmitted. If this happens, either open the [Ports] tab in the printdriver Properties dialog box, and enable the LPR byte count, orchange the size of spooling memory so that it is larger than the size ofthe document.IPP Spool• [No Spooling] (default)Spooling is not performed. Data cannot be simultaneously printedand received using the IPP interface. Set the memory size of thereceiving buffer exclusively for IPP from 64 to 1024 KB in 32 KBincrements. The default is [256K].• [Hard Disk]Spooling to the hard disk is performed. The hard disk is used as thereceiving buffer for spooling.Note• [IPP Spool] appears only when HDD Extension Kit (optional) isinstalled. [IPP] is displayed when HDD Extension Kit is not installed.5.2 Common Menus Setting 207