Download - Fuji Xerox Printers

SettingPort StatusDescriptionSets whether to enable or disable the ThinPort port at printer start-up.• [Enabled]• [Disabled] (default)Port Number Sets the port number from 1 to 65535. (See *2 on P. 214.)• [4000] (default)Note• Set only unique port numbers.SSL/TLSSets whether to enable or disable SSL encrypted communications.• [Disabled] (default)• [Enabled]Note• Client certificate is necessary for SSL communications.Configure an appropriate certificate on the printer.[SNMP]Note• SNMP must be configured when using an application to remotely manage multiple printers. SNMPmanages printer information and provides it to the management application.Network/PortSNMPSNMPPort StatusSNMPTransportProtocolSettingPort StatusDescriptionSets whether to enable or disable the SNMP port at printer start-up.• [Enabled] (default)• [Disabled]Important• If the printer runs out of memory when the port is enabled, the port issometimes automatically disabled. If this happens, either disable unusedports, or change the memory allocation under [Allocate Memory].TransportProtocolSets the protocol of the transport layer used by SNMP. Either or both of IPXand UDP can be selected.• [UDP] (default)• [IPX]• [IPX, UDP]Note• When using UDP protocol, both the printer and client computers must haveIP addresses.• To determine which protocol (IPX or UDP) to use, refer to the manualsupplied for the application.160 5 Control Panel Settings