Download - Fuji Xerox Printers

5. Loosen the three screws on the back rightside of the printer.screw6. Pull out the handle on the control board andthen carefully pull the control board out ofthe printer. Place the control board on atable top or some other flat surface.Important• When pulling out the control board, hold it with bothhands so you do not drop it.7. Aligning the notch in the memory card withthe tab in the M2 slot, insert the cardstraight into the slot.Important• A 1024 MB memory is installed into the M1 Slot asstandard.Press the memory card down firmly into theslot.Note• Make sure the extension system memory card isinserted securely as far as it can go.• When the memory card is installed correctly, theretaining clips on both ends stand up.8. Reinsert the control board back into theprinter. Holding its handle, slide the controlboard back into the printer.408 A Appendix