Download - Fuji Xerox Printers

2. Open the front cover.3. Press the < > side of the printer’s mainpower switch to turn off the main power.Note• The lamp goes out on the controlpanel.4. Insert the connector conversion cableincluded with the optional Parallel Port Kitinto the interface connector on the printer.5. Connect the other end of the connectorconversion cable to the connector on theparallel cable. Then secure it using themetal pieces on both sides of theconnector.6. Plug the other end of the parallel cable intoyour computer.7. Press the < | > side of the printer’s mainpower switch to turn on the main power andthen close the front cover.8. Press the < | > side of the printer’s powerswitch to turn on the power.Note• Message [Ready to print IP Address failed] may bedisplayed on the control panel. To erase this message,set to [STATIC] in [Network/Port] > [TCP/IP Settings] >[IPv4 Settings] > [Get IP Address] to specify IPaddress (Example: 192.168.1.100) or [Disabled] foreach port other than the Parallel port in [Network/Port].Refer to• For setting method of IP address, refer to “1.4 Settingthe Network Environment” (P. 36).• For setting each port, refer to “1.5 Enabling Ports”(P. 40).34 1 Printer Environment Settings