Download - Fuji Xerox Printers

5. Loosen the three screws on the controlboard of the printer.screw6. Pull out the handle on the control board andthen carefully pull the control board out ofthe printer. Place the control board on atable top or some other flat surface.Important• When pulling out the control board, hold it with bothhands so you do not drop it.7. Widely open the tabs on each side of theR2 slot as shown in the right figure, andthen insert the Feature Enhance Kit ROMstraight into the R2 slot with aligning thenotch in the ROM with the concavity of theR2 slot.Important• The slot R1 is for other optional kit. Do not insert theFeature Enhance Kit into the slot R1.Press the ROM card down firmly into theslot.Note• Make sure the ROM card is inserted securely as far asit can go.• When the ROM card is installed correctly, the retainingclips on both ends stand up.8. Reinsert the control board back into theprinter. Holding its handle, slide the controlboard back into the printer.Important• Be sure to hold the handle when inserting the controlboard. The control board may be damaged if youinsert it with the handle being folded.414 A Appendix