Administration HiPath 3000/5000 V7 IP systems

3000sb2.fm
HiPath 3000 System Overview For internal use only
HiPath 3350
● Power consumption: approx. 90W
● Bridging times
The following table lists the maximum bridging times (battery operation in case of power
failure) available with the battery pack S30122-K5928-X (48 V/1.2 Ah).
Table 2-18 UPSC-D - Bridging Times with Battery Pack S30122-K5928-X (48 V/
1.2 Ah)
System Power supply
unit
HiPath 3350 UPSC-D Normal output load = 5 V/3 A;
–48 V/0.5 A; ringing approx. 2 VA
Measurement conditions:
2.4.3.4 LIM
Load levels Maximum bridging
time
19 min
● All measurements were performed at a room temperature of approximately 23 °C
(73.4°F).
● The batteries were fully charged when the measurement was started.
The LAN Interface Module (LIM - S30807-Q6930-X) is an optional plug-in card for all HiPath
3000 central control boards (see also Section 4.4).
The board provides an Ethernet (10BaseT/10 Mbps) LAN connection via an 8-pin RJ45 jack.
The LIM module can be used for administration via HiPath 3000/5000 Manager E and for CTI
functions (TAPI 120 V2.0). However, bear in mind that the number of BHCAs (Busy Hour Call
Attempts = number of connection attempts during busy traffic hours) is restricted to 400 at a
maximum of six TAPI ports. The use of "power dialers" is not approved.
You cannot operate the LIM module and a HG 1500 board simultaneously in one system.
P31003-H3570-Y100-4-7618, 2007-10-31
2-46 HiPath 3000/5000 V7, System Description