Administration HiPath 3000/5000 V7 IP systems

3000sb1.fm
For internal use only Introduction
Features
1.5.5 Protocol Extensions for HiPath ProCenter Agile
You can use a "multiple pilot station number" to access the same UCD group with different station
numbers. This function is implemented by configuring a virtual station in Call Management.
The "multiple pilot station number" is treated like a "call forwarding" number. Information about
the "multiple pilot station number" is "delivered" by the last call forwarding destination and
"queued" in the relevant UCD group.
1.5.6 CSTA Interface
The station can address the associated CSTA application (if this was previously registered at
the HiPath system) by selecting an application ID. A registered application can address a station
directly (for example, to confirm an action on the display).
Internet telephony service provider trunks can be integrated in CSTA applications. This means
that for CSTAs, there are no longer any differences between TDM trunks and Internet telephony
service provider trunks.
You can start an I/O session with a feature code or function key. You can use the function key
to start, resume, and stop an I/O session; the function key LED indicates the status of the I/O
session (standby, active, suspended).
During an I/O session, a subscriber can operate the application using the following navigation
keys:
● the keypad
● plus/minus keys
● the alphanumeric keyboard (Optiset Memory)
● the programmable keys and softkeys (CMI)
Up to ten applications can be simultaneously logged on to a system.
A single I/O session can only be used by one station at a time. If a session is interrupted ("suspended"
status), a second I/O session cannot be started; the interrupted session must first be
ended.
Internet telephony service provider trunks can be integrated in applications that are connected
to the HiPath system via the CSTA interface.
P31003-H3570-Y100-4-7618, 2007-10-31
HiPath 3000/5000 V7, System Description 1-11