Administration HiPath 3000/5000 V7 IP systems

3000sb2.fm
HiPath 3000 System Overview For internal use only
HiPath Cordless Office
2.10 HiPath Cordless Office
2.10.1 Introduction
For Version 1.2 and later of HiPath 3000, HiPath Cordless Office can be used on all systems of
this product line.
Direct connection
The BS3/1 (S30807-H5482-X) and BS4 (S30807-U5491-X) base stations can be connected directly
to the U P0/E interfaces on the central control boards in the HiPath 3550, HiPath 3350, Hi-
Path 3500, and HiPath 3300. The connection must be made via one U P0/E interface each. A
mix of base stations of types BS3/1 and BS4 is supported.
To ensure the operation of a maximum of one base station on the central control board’s U P0/
E interfaces of the HiPath 3550, HiPath 3350, HiPath 3500, and HiPath 3300, a BS3/S (X30807-
X5482-X100) single-cell base station can be used. In this case, it is not possible to expand with
additional base stations.
However, base stations cannot be simultaneously connected to the SLC16/SLC16N board and
the CBCC within one HiPath 3550 system.
> The base stations BS3/1 (S30807-H5482-X), BS3/3 (S30807-H5485-X), and BS3/S
Connecting cordless boards
Base stations can be connected to the U P0/E interfaces of the following cordless boards:
● SLC16N with HiPath 3550
● SLCN in HiPath 3800
> The SLC16 (S30810-Q2922-X) board is no longer supported in HiPath 3000/5000
(X30807-X5482-X100) are being phased out and can not longer be ordered. Use the
successor product BS4 (S30807-U5491-X) instead of the types specified.
You can continue to operate the base stations specified in conjunction with HiPath
3000. A mix of base stations of types BS3/1, BS3/3, and BS4 is also supported.
V6.0 and later systems.
P31003-H3570-Y100-4-7618, 2007-10-31
2-80 HiPath 3000/5000 V7, System Description