Administration HiPath 3000/5000 V7 IP systems

3000sb5.fm
For internal use only Serviceability
Options in the Service Department
5.3.11.2 Issuing and Saving Log Data
Data is automatically logged in an area (LOG area) on the MCC reserved for this purpose. It
cannot be switched off.
If approximately 80 % of the MMC log area capacity is exceeded, a Class A error is issued.
This error is dealt with like all Class A errors and is displayed on the optiPoint Attendant as “Revisor
Alarm.”
The log should now be read out and archived, in other words it should be saved in an archive file
(file extension = arc). If an archive is not created, the oldest datablock is overwritten if there is
a danger of overflow.
You can only issue log entries using HiPath 3000/5000 Manager E. You cannot retrieve the log
entries from the system until you have logged on as a user with “Revisor” rights.
Archive
If you request an archive (storage), the system checks whether or not there is already an archive
file (file extension = arc). If it is a file with log data from a previous archive, the file must
match the current customer. In case of a positive result, the system log entries are retrieved
and attached to the existing data in the archive file. At the same time, the data in the system
is deleted.
If malfunctions occur during this procedure (for example, line interruption), the entire procedure
ends and the archive has to be restarted.
If no archive is requested, the revisor can retrieve, view, and print the log entries. However, log
entries remain in the system.
Multimedia Card (MMC)
When replacing the multimedia card, the following applies:
● If the memory area for logging data is empty, logging restarts.
● If the memory area for logging data is not empty, logging continues.
P31003-H3570-Y100-4-7618, 2007-10-31
HiPath 3000/5000 V7, System Description 5-43