Administration HiPath 3000/5000 V7 IP systems

3000sb5.fm
For internal use only Serviceability
Options in the Service Department
5.3.8 Error Correction
5.3.8.1 Automatic Error Correction
One of the below recovery actions is assigned to each error in the error memory. These recovery
actions are programmed to automatically correct errors that occur.
● Hard restart
● Reload board
● Reload CDB backup
● Port lockout
● Power failure transfer (loop start)
● None
A watchdog activates continuous loops.
If no recovery measure is assigned or if the one that is assigned fails, a service technician has
to correct the error manually.
5.3.8.2 Manual Error Correction Without HiPath 3000/5000 Manager E
Manually Activating Restart (Reset)/Reload
Pressing the reset button on the central control board
● initiates a Reset (Hard restart of the entire system with the current CDB) if the button is
pressed for less than 5 seconds. The Run LED lights up when the Reset button is pressed.
● initiates a Reload if the button is pressed longer than 5 seconds. The Run LED disappears
after approximately five seconds as verification that the reload has been initiated. The entire
content of the customer database is replaced by its default version. All country and customer-specific
settings are lost.
Locking out and Releasing Boards and Ports
You can lock out and release ports using the lockout switch located on the board. The lockout
prevents renewed seizure after the current connection has finished. It creates
● a port lockout in an outgoing direction on analog trunk boards.
● a port lockout in outgoing and incoming directions on trunk boards.
● a lockout of the entire board for subscriber line modules.
P31003-H3570-Y100-4-7618, 2007-10-31
HiPath 3000/5000 V7, System Description 5-27