Administration HiPath 3000/5000 V7 IP systems

3000sb4.fm
HiPath 3000/5000 in the LAN Network For internal use only
IP Trunking
● Data can be transmitted via modem over the IP network at a speed of 33.6 kbps using the
ITU-T standard V.42.
● Data transmission to the ITU-T standard X.75
Support of Network-wide Features
The CorNet N protocol is supported for IP networking. which means that CorNet-N-specific features
are transmitted over the IP network (tunnelling).
The following applies: Overall, the features that are transmitted today in the HiPath 3000/5000
Corporate Network, are also transmitted in the IP network although the old network has been
enhanced in certain respects (see Section 4.6.3, “Network-Wide Features with IP Networking”).
Central Attendant Console
A central, system-wide attendant console can be configured within the IP network. The network-wide
busy signal option is possible here.
> The network-wide busy signal is only available with optiClient Attendant.
Automatic Routing
Automatic routing to a backup or alternative network can be executed for new connections. A
voice network (ISDN, for example) can also operate as a backup network. This ensures that
the high availability of the HiPath 3000/5000 will not be affected when IP networks are being
used by voice and fax connections. Automatic routing is initiated if
● the communications platform called is not available
(due to faults or an overload in the IP network for example).
● no further capacity available for LAN access
(maximum number of B channels for LAN gateway exceeded).
● explicitly requested for connections (fax or modem connections, for example).
> ISDN lines are required as a trunk connection for routing data connections/VoIP con-
nections over the integrated ISDN router.
P31003-H3570-Y100-4-7618, 2007-10-31
4-64 HiPath 3000/5000 V7, System Description