02 - BTI - We know your business

WWW.bTI-gROUP.COM
08
A
�����
gun foam OZ-SR
g 1K installation foam
g Hardening takes place by absorption of humidity
from the air or the surrounding materials
g Moisturize the surface to ensure material-specific
volume expansion
g Observe instruction manual acc. to can label
g Assessed sound reduction rate 57 db for sound
protection windows to including sound protection
class 5
g Rubber valve
g Long, thin tin plate can
g To be processed with installation foam guns
Processing instructions:
Processing is carried out with the SP1 applicator gun
(item no. 015557).
Foam and gun cleaner
To clean and rinse guns and to remove foam splashes
BONDING + SEALING
Technical data
(at +23 °C/50 % relative air humidity, joint width 3 cm)
Yield foamed free approx. 45 l
Foam expansion approx. 100% – 150%
Usage temperature +5 to +30 °C
Surface temperature ≥ 5 °C
Adhesive-free approx. 10 min
Sliceable approx. 20 -30 min
Curing approx. 1 h
Strainable approx. 3 – 5 hrs
Storage 9 months
Item Unit Color Content
number Pieces ml
006659 12 bright yellow 750
Item Unit Designation Container Content Application
number Pieces ml
08-652 A/P/T 08652AA
338095 1/12 PU foam cleaner can 150 to remove fresh
foam splashes
323462 1/12 Gun cleaner can 500 for monthly rinsing
of applicator foam gun
002730 1/12 Gun cleaner can 500 to clean the PG2-S
PG2-S applicator gun
08-659 A/P 08659
Note:
The cleaner may etch varnished surfaces and plastics. If required, and to be on the safe side, test the cleaner
beforehand on relevant subsurfaces in a non-visible area.
Applicator gun SP1
For all 1K installation foams with M65 thread adapter
g High grade starter gun
High grade technology in a cost-optimized model
g Controlled production
The foam egression amount is measured with the
trigger, via a set screw the maximum egression
amount can be limited and thus an even application
ensured
g Dosing in tight places too
A special spray enables extending the dosage pipe
with a plastic pipe
Range of application:
To process any standard gun foams which have an M65
thread adapter ring
Processing instructions:
Never store an operated gun without screwed-on foam
can. The system must always be filled to the nozzle with
foam.
Never clean the adapter with a hard object, as antiadhesion
coating will be damaged.
Item Unit Designation
number Pieces
015557 1 Applicator gun SP1
The details specified in this publication are based on our current knowledge and experience. Due to the abundance of possible processing and application influences this information does not release the processor from performing his
584 own tests and trials. Legally binding assurance of certain characteristics or suitability for a concrete implementation objective can not be derived from this information.
1006
08-653