CDC 1725/DCC 2725 CDC 1730/DCC 2730 CDC 1740/DCC 2740 ...

Copying Functions
OHP Backing Sheet Mode
When two or three OHP transparencies are stacked on top of each other, static electricity may make them
difficult to handle. When using OHP Backing mode, a paper sheet is automatically inserted between each
transparency, making them easier to handle. Also, the same original page can be copied to the backing sheet
for multiple page copying.
NOTE: Never load OHP transparencies into trays or cassettes other than the multi purpose tray.
When OHP Backing mode is set, the multi purpose tray paper type is automatically set to Transparency.
If the optional document finisher or 3,000 sheet document finisher is installed, you may need to specify the
output destination for finished copies. For further details, refer to Output Destination on page 4-13.
Blank Sheet
1
*
Outputs a blank backing sheet after copying to a
transparency. (* denotes OHP film.)
1
2
3
2
*
3
*
Original
Copy
Copied Sheet
1
2
3
1
*
1
2 *
2
3
*
3
After copying to a transparency, copies the same
original image to the backing sheet paper. (* denotes
OHP film.)
Original
Copy
Follow the steps below for OHP Backing Sheet mode.
1 Press Copy key.
2 Place the original.
3 Load the transparencies into the multi purpose tray.
IMPORTANT: Fan through the transparencies before
loading.
Up to 10 transparencies can be loaded at one time.
Be sure that paper of the same size and orientation as
the transparencies is loaded in the cassette.
4-52 OPERATION GUIDE