CDC 1725/DCC 2725 CDC 1730/DCC 2730 CDC 1740/DCC 2740 ...

Default Setting (System Menu)
TCP/IP (IPv6) Setup
Set up TCP/IP (IPv6) to connect to the network. The default settings are "TCP/IP Protocol: On, TCP/IP (IPv6):
On, DHCP (IPv6): On, RA (Stateless): On".
Use the procedure below to setup the TCP/IP (IPv6) setting.
DHCP (IPv6) Settings
1 Press the System Menu key.
2 Press [System], [Next] of Network and then [Next]
of TCP/IP Setting.
3 Press [Change] of TCP/IP.
4 Press [On] and then press [OK].
5 Press [Change] of IPv6.
6 Press [On].
7 Press [OK].
Select whether or not to use the DHCP (IPv6) server. The default setting is On.
Use the procedure below to specify the DHCP (IPv6) setting.
8 After changing the setting, restart the system or
turn the machine OFF and then ON again.
For detailed information on restarting the system,
refer to Restarting the System on page 8-88.
1 Press the System Menu key.
2 Press [System], [Next] of Network and then [Next]
of TCP/IP Setting.
3 Press [Change] of TCP/IP.
4 Press [On] and then press [OK].
5 Press [Change] of IPv6.
6 Press [On].
7 Press [DHCP].
8 Press [On] or [Off] of DHCP.
9 Press [OK].
10 After changing the setting, restart the system or
turn the machine OFF and then ON again.
For detailed information on restarting the system,
refer to Restarting the System on page 8-88.
8-90 OPERATION GUIDE