CDC 1725/DCC 2725 CDC 1730/DCC 2730 CDC 1740/DCC 2740 ...

Default Setting (System Menu)
Network Security
The network security functions can be set up to protect printer operation and the print data.
The following network security settings are available.
• SSL Setting …8-97
• SNMPv3 Setting …8-98
• IPSec Setting …8-99
SSL Setting
This allows you to use SSL network security for communication. You can use SSL Setup to select whether or
not SSL is used and to specify the IPP port and HTTP port security settings.
Use the procedure below to specify the SSL settings.
1 Press the System Menu key.
2 Press [System], [Next] of Network Security, and
then [Next] of SSL Setting.
NOTE: If user login administration is disabled, the
user authentication screen appears. Enter your login
user name and password and then press [Login]. For
this, you need to log in with administrator privileges.
Refer to Adding a User on page 11-4 for the default
login user name and password.
8
3 Press [Change] of SSL.
4 Press [On].
5 Press [OK].
To set IPP port
1 Press [Change] of IPP Port Setting.
2 Press [IPP over SSL Only] or [IPP or IPP over
SSL].
3 Press [OK].
To set HTTP port
1 Press [Change] of HTTP Port Setting.
2 Press [HTTP or HTTPS] or [HTTPS Only].
3 Press [OK].
6 After changing the setting, restart the system or
turn the machine OFF and then ON again.
For detailed information on restarting the system,
refer to Restarting the System on page 8-88.
OPERATION GUIDE 8-97