CDC 1725/DCC 2725 CDC 1730/DCC 2730 CDC 1740/DCC 2740 ...

Default Setting (System Menu)
Auto Sleep
If no job runs for a certain period of time, automatically enter Sleep Mode. Refer to Sleep and Auto Sleep on
page 3-5 for Sleep Mode.
Auto Sleep ON/OFF
Select whether to use Auto Sleep or not.
NOTE: Time remaining before Auto Sleep can be modified as necessary.
Use the procedure below to specify the auto sleep setting.
1 Press the System Menu key.
2 Press [ ], [Date/Timer] and then [Change] of Auto
Sleep.
3 Press [Off] or [On].
4 Press [OK].
Sleep Timer
If you select [On] for Auto Sleep, set the amount of time to wait before Auto Sleep. Options are between 1 and
240 minutes (every one minute).
8
NOTE: If you select [Off] for Auto Sleep, the time display does not appear.
Use the procedure below to set the Auto Sleep time.
Auto Error Clear
1 Press the System Menu key.
2 Press [ ], [Date/Timer] and then [Change] of
Sleep Timer.
3 Press [+] and [–] or the numeric keys to enter the
time until Auto Sleep is turned on.
4 Press [OK].
If an error occurs during printing, the print job stops to wait for the next step to be taken by the user. In the Auto
Error Clear mode, automatically clear the error after a set amount of time elapses.
The following errors are automatically cleared.
Print overrun
Memory is full
OPERATION GUIDE 8-69