CDC 1725/DCC 2725 CDC 1730/DCC 2730 CDC 1740/DCC 2740 ...

Default Setting (System Menu)
Border Erase Default
Set the default width to be erased as a border. The table below shows the measurement ranges that can be set.
Input units
Range
Inch
Metric
0 to 2" (in 0.01" increments)
0 mm to 50 mm (in 1 mm increments)
NOTE: Refer to page 4-27 and page 5-26 for Border Erase.
Use the procedure below to set the default border erase width.
1 Press the System Menu key.
2 Press [Common Settings], [ ], [Next] of Function
Defaults, [ ] and then [Change] of Border Erase
Default.
3 Press [+] or [–] for the Border and Gutter width to
erase.
You can use the number keypad to enter the
number directly.
8
4 Press [OK].
Margin Default
Set the default margin. The table below shows the measurement ranges that can be set.
Input units
Range
Inch
Metric
-0.75 to 0.75" (in 0.01" increments)
-18 mm to 18 mm (in 1 mm increments)
Use the procedure below to set the default margin width.
1 Press the System Menu key.
2 Press [Common Settings], [ ], [Next] of Function
Defaults, [ ] and then [Change] of Margin Default.
3 Use the [+] or [-] to enter the margin widths for Left/
Right and Top/Bottom(-0.75 - +0.75).
You can use the number keypad to enter the
number directly.
4 Press [OK].
OPERATION GUIDE 8-27