CDC 1725/DCC 2725 CDC 1730/DCC 2730 CDC 1740/DCC 2740 ...

Troubleshooting
Responding to an Error Lamp Flashes
If an error lamp flashes, press [Status/Job Cancel] to check an error message. If the message is not indicated
on the touch panel when [Status/Job Cancel] is pressed or the error lamp flashes for 1.5 seconds, check the
following.
Symptom Checkpoints Corrective Actions Reference Page
Cannot send fax.
Is the modular cord
connected correctly?
Connect the modular
cord correctly.
—
Is Permitted FAX No. or
Permitted ID No.
registered correctly?
Check Permitted FAX
No. and Permitted ID
No..
FAX System (Q)
Operation Guide
Chapter 6 "Registering
Permit FAX No." and
"Registering Permit ID
No."
Has a communication
error occurred?
Check error codes in the
TX/RX Result Report
and Activity Report. If
the error code starts with
"U" or "E", perform the
corresponding
procedure.
FAX System (Q)
Operation Guide
Appendix
"Error Code List"
Is the destination FAX
line busy?
Send again. —
Does the destination
FAX machine respond?
Is there an error other
than above?
Send again. —
Contact your Service
Representative.
—
10
OPERATION GUIDE 10-13