CDC 1725/DCC 2725 CDC 1730/DCC 2730 CDC 1740/DCC 2740 ...

Sending Functions
Border Erase to Back Page
When scanning a 2-sided original, this allows you to erase the borders on the back of the original. The table
below shows the available settings.
Item
Same as Front
Page
Do Not Erase
Detail
Border Erase performed using the same setting
as the front page
No Border Erase performed on the back page
NOTE: You can change the default setting for Border Erase to Back Page. For details, refer to Border Erase
for Back Page on page 8-32.
5
Use the procedure below to erase borders when sending scanned originals.
1 Press the Send key.
2 Place the originals on the platen.
3 Press [Advanced Setup] and then [Border Erase].
Border Erase
Original
Zoom
Paper
Ready to send.
Place original.
Place original.
: ---
: 100%
: ---
Off
Border Erase
Sheet
Border Erase
Book
Individual
Border Erase
Border
Gutter
(0 - 50)
6 mm
# Keys
(0 - 50)
6 mm
Destination
Same as
Front Page
Back Page
4 Press [Border Erase Sheet] to erase borders for an
individual sheet or [Border Erase Book] to erase
borders for a book.
Use [+] or [-] to enter the width in Border or Gutter.
Press [# Keys] to use the number keys for entry.
Press [Individual Border Erase] to select the
individual border erase.
Preview
# Keys
Add Shortcut
Cancel
OK
10/10/2008 Status 10:10
Use [+] or [-] to enter the border width or press [#
Keys] and enter the width using the numeric keys.
Border Erase
Ready to send.
Place original.
Place original.
Off
Border Erase
Sheet
Border Erase
Book
Top
Bottom
Left
(0 - 50)
6 mm
6
mm
6
mm
Destination
Same as
Front Page
Back Page
Press [Original Orientation] to select the original
orientation from either [Top Edge Top] or [Top Edge
Left], and press [OK].
For 2-sided originals, press [Back Page] and then
press [Same as Front Page] or [Do Not Erase].
Original
Zoom
Paper
: ---
: 100%
: ---
Preview
Individual
Border Erase
Right
# Keys
6 mm
Top Edge Top
Original
Orientation
Add Shortcut
Cancel
OK
Status 10/10/2008 10:10
5 Press [OK].
6 Specify the destination, and press the Start key to
start sending.
OPERATION GUIDE 5-27