CDC 1725/DCC 2725 CDC 1730/DCC 2730 CDC 1740/DCC 2740 ...

Troubleshooting
Responding to Error Messages
If the touch panel displays any of these messages, follow the corresponding procedure.
Alphanumeric
Error Message Checkpoints Corrective Actions
Reference
Page
Acceptable staple
count exceeded.
Is the acceptable staple
count exceeded? For
details, refer to
Specifications on page
Appendix-9,10,11.
Press [Continue] to print without
stapling.
Press [Cancel] to cancel the job.
—
Add paper in cassette
1.
Is the indicated cassette out
of paper?
Load paper. 2-16
Add paper in Multi
Purpose tray.
Is the paper of the selected
size loaded in the multi
purpose tray?
Load the paper in the multi purpose
tray which is of the size and type
indicated on the touch panel.
2-20
Add staples.
Has any of the document
finisher run out of staples?
If the staples are depleted, the
machine will stop and the location of
staple depletion will be indicated on
the touch panel.
Leave the machine on and follow the
instruction to replace the staple case.
Press [Continue] to print without
stapling.
Press [Cancel] to cancel the job.
—
Add toner.
[C][M][Y][K]
– Replace the toner container. 9-8
Box is not found. – This job is canceled because the
specified box cannot be found. Press
[End].
Box limit exceeded. – Document box is full, and no further
storage is available; Job is canceled.
Press [End].
– Repeat Copy box is full, and no
further repeat copy is available.
Press [Continue] to print without
using Repeat Copy.
Press [Cancel] to cancel the job.
—
—
—
10-6 OPERATION GUIDE