CDC 1725/DCC 2725 CDC 1730/DCC 2730 CDC 1740/DCC 2740 ...

Default Setting (System Menu)
3 Press [Off] or [On].
4 Press [OK].
Panel Reset Timer
If you select [On] for Auto Panel Reset, set the amount of time to wait before Auto Panel Reset. Options are
between 5 and 495 seconds (every five seconds).
NOTE: If you select [Off] for Auto Panel Reset, the time display does not appear.
Use the procedure below to set the reset time.
Low Power Timer
1 Press the System Menu key.
2 Press [ ], [Date/Timer] and then [Change] of
Panel Reset Timer.
3 Press [+] or [–] to enter the time until Auto Panel
Reset is turned on.
You cannot use the number keypad to enter this
value.
4 Press [OK].
You can specify the amount of time to wait before Low Power Mode.
Specify a value from 1 - 240 minutes (1 minute increments).
For more information on Low Power Mode, refer to the Low Power Mode and Auto Low Power Mode on page
3-4.
Use the procedure below to set the Low Power Mode.
1 Press the System Menu key.
2 Press [ ], [Date/Timer] and then [Low Power
Timer].
3 Press [+],[–] or the numeric keys to enter the time
until Low Power Mode is turned on.
4 Press [OK].
8-68 OPERATION GUIDE