CDC 1725/DCC 2725 CDC 1730/DCC 2730 CDC 1740/DCC 2740 ...

Default Setting (System Menu)
RA (Stateless) Settings
Select whether or not to use RA (Stateless).The default setting is On.
Use the procedure below to set the ICMPv6 (NDP) setting.
1 Press the System Menu key.
2 Press [System], [Next] of Network and then [Next]
of TCP/IP Setting.
3 Press [Change] of TCP/IP.
4 Press [On] and then press [OK].
5 Press [Change] of IPv6.
6 Press [On].
7 Press [RA(Stateless)] .
8 Press [On] or [Off] of RA (Stateless).
9 Press [OK].
10 After changing the setting, restart the system or
turn the machine OFF and then ON again.
8
For detailed information on restarting the system,
refer to Restarting the System on page 8-88.
NetWare Setup
Select the NetWare network connection. After that, select frame types for NetWare network from Auto,
Ethernet-II, 802.3, 802.2, or SNAP. The default settings are "On, Frame Type: Auto".
Use the procedure below to setup the NetWare setting.
1 Press the System Menu key.
2 Press [System], [Next] of Network and then
[Change] of NetWare.
System - NetWare
3 Press [On].
Use NetWare to receive documents.
Off
Frame Type
Auto
Ether-II
On
802.3
802.2
SNAP
Cancel
OK
Status 10/10/2008 10:10
4 Press the key for the frame type you want to use.
OPERATION GUIDE 8-91