ts_125331v120300p

3GPP TS 25.331 version 12.3.0 Release 12
106
ETSI TS 125 331 V12.3.0 (2014-10)
8.1.1.6.20 System Information Block type 20
If the cell is not operating in MBSFN mode according to subclause 8.1.1.6.3, the UE shall:
1> if the IE "HNB Name" is present:
2> forward the content of IE "HNB Name" to the upper layers.
8.1.1.6.21 System Information Block type 21
The EAB capable UE should store all relevant IEs included in this system information block. If the IE "EAB
Parameters" is included, the EAB capable UE shall:
1> if the IE "EAB Parameters For All" is included in the IE "EAB Parameters":
2> select the IE "EAB Parameters For All".
1> else:
2> select the entry in the IE "EAB Parameters Per PLMN List" in the IE "EAB Parameters" corresponds to the
PLMN chosen by the UE.
1> if in idle mode:
2> if the IE "CS Domain Specific EAB parameters" or the IE "Common EAB parameters" is included in the
selected Domain Specific EAB Parameters:
3> act on the IE "EAB Access Class Barred List" when initiating RRC Connection establishment to send an
INITIAL DIRECT TRANSFER message to the CS domain, if upper layers indicate that the connection
request is subject to EAB and the UE belongs to the category of UEs as indicated in the IE "EAB
Category".
2> if the IE "PS Domain Specific EAB parameters" or the IE "Common EAB parameters" is included in the
selected Domain Specific EAB Parameters:
3> act on the IE "EAB Access Class Barred List" when initiating RRC Connection establishment to send an
INITIAL DIRECT TRANSFER message to the PS domain, if upper layers indicate that the connection
request is subject to EAB and the UE belongs to the category of UEs as indicated in the IE "EAB
Category".
1> if in connected mode:
2> store the selected Domain Specific EAB Parameters to the variable "EAB_PARAM" upon transition to RRC
connected and maintain the variable until it is cleared, the PLMN chosen by the UE is changed or the RRC
connection is released.
2> if the IE "CS Domain Specific EAB parameters" or the IE "Common EAB parameters" is included in the
stored Domain Specific EAB Parameters in variable "EAB_PARAM":
3> act on the IE "EAB Access Class Barred List" when initiating an INITIAL DIRECT TRANSFER
message to the CS domain, if upper layers indicate that the connection request is subject to EAB and the
UE belongs to the category of UEs as indicated in the IE "EAB Category" and signalling connection to
the PS domain is already established.
2> if the IE "PS Domain Specific EAB parameters" or the IE "Common EAB parameters" is included in the
stored Domain Specific EAB Parameters in variable "EAB_PARAM":
3> act on the IE "EAB Access Class Barred List" when initiating an INITIAL DIRECT TRANSFER
message to the PS domain, if upper layers indicate that the connection request is subject to EAB and the
UE belongs to the category of UEs as indicated in the IE "EAB Category" and signalling connection to
the CS domain is already established.
8.1.1.6.22 System Information Block type 22
The UE should store all relevant IEs included in this system information block.
ETSI