ts_125331v120300p

3GPP TS 25.331 version 12.3.0 Release 12
430
ETSI TS 125 331 V12.3.0 (2014-10)
8.5.68.2 Initiation
The UE initiates the procedure to release the existing logging measurements configuration upon receiving a new
Logged ANR Configuration in UTRAN. The UE also shall initiate the procedure after sending UE INFORMATION
RESPONSE message as well as upon switch off or detach.
The UE shall:
1> if stored, discard the existing logged measurement configuration as well as the logged measurement information,
i.e. release the UE variables LOG_ANR_CONFIG and LOG_ANR_REPORT_VARIABLE and stop timer
T327.
8.5.69 Actions related to UPLINK_CLTD_TRANSMISSION variable (FDD
only)
The variable UPLINK_CLTD_TRANSMISSION shall be set to TRUE only when all the following conditions are met:
1> the UE is in CELL_DCH state;
1> the UE has stored IE "Uplink CLTD info FDD";
1> the UE has stored IE "F-TPICH info" for the radio link transmitted from the serving HS-DSCH cell if HS-DSCH
is configured or from the cell identified by the IE "Primary CPICH info" in the IE "Uplink CLTD info FDD" if
only DCH is configured;
1> the UE is configured with MAC-i/is if E-DCH is configured;
1> the variable SECONDARY_CELL_E_DCH_TRANSMISSION is set to FALSE if the UE supports Dual Cell E-
DCH operation.
If any of the above conditions is not met and the variable UPLINK_CLTD_TRANSMISSION is set to TRUE, the UE
shall:
1> set the variable UPLINK_CLTD_TRANSMISSION to FALSE;
1> stop the F-TPICH reception procedure;
1> trigger lower layers to stop the uplink CLTD transmission;
1> clear the stored IE "Uplink CLTD info FDD".
If all of the above conditions are met and the variable UPLINK_CLTD_TRANSMISSION is set to FALSE, the UE
shall:
1> set the variable UPLINK_CLTD_TRANSMISSION to TRUE;
1> instruct the physical layer to switch to the uplink CLTD activation state as indicated by the IE "Initial CLTD
activation state" (see [27]).
Whenever the variable UPLINK_CLTD_TRANSMISSION is set to TRUE, the UE shall:
1> perform the F-TPICH reception procedure;
1> trigger lower layers to perform the uplink CLTD transmission.
Whenever the variable UPLINK_CLTD_TRANSMISSION is set to FALSE, the UE shall:
1> not perform the F-TPICH reception procedure;
1> not perform the uplink CLTD transmission.
If the variable UPLINK_CLTD_TRANSMISSION is set to TRUE and the serving HS-DSCH cell was changed as a
result of the received message or HS-SCCH order from the target cell, and the IE "Initial CLTD activation state" is
included, the UE shall instruct the physical layer to switch to the uplink CLTD activation state as indicated by the IE
"Initial CLTD activation state" (see [27]).
ETSI