ts_125331v120300p

3GPP TS 25.331 version 12.3.0 Release 12
417
ETSI TS 125 331 V12.3.0 (2014-10)
1> if the UE is requested to move into CELL_FACH state by paging type 1 as described in subclause 8.1.2.3, UE
shall:
2> move the UE to CELL_FACH state;
2> set the variable HSPA_RNTI_STORED_CELL_PCH to FALSE;
2> stop timer T319 if it is running;
2> restart the timer T305 if it is set to any value other than "infinity";
2> determine the value for the READY_FOR_COMMON_EDCH variable and take the corresponding actions as
described in subclause 8.5.47;
2> determine the value for the COMMON_E_DCH_TRANSMISSION variable and take the corresponding
actions as described in subclause 8.5.46;
2> for FDD, determine the value for the READY_FOR_COMMON_ERGCH variable and take the
corresponding actions as described in subclause 8.5.75;
2> for FDD and 1.28 Mcps TDD:
3> initiate the measurement report procedure as specified in subclause 8.4.2;
3> not prohibit periodical status transmission in RLC;
3> configure the Enhanced Uplink in CELL_FACH state and Idle mode as specified in subclause 8.5.45 for
FDD and 8.5.45a for 1.28 Mcps TDD;
3> start to receive HS-DSCH according to the procedure in subclause 8.5.36.
8.5.57 Actions related to SECONDARY_CELL_MIMO_STATUS variable
If the UE receives an ACTIVE SET UPDATE, CELL UPDATE CONFIRM, or any reconfiguration message which
includes the IE "Downlink secondary cell info FDD" for any of the secondary serving HS-DSCH cells, the UE shall:
1> if the IE "Secondary cell MIMO parameters" is not included in the IE "Downlink secondary cell info FDD":
2> clear the corresponding entry in the SECONDARY_CELL_MIMO_PARAMS variable;
1> if the CHOICE "Configuration Info" in the IE "Secondary cell MIMO parameters" has the value "Continue":
2> continue using the stored parameters in the corresponding entry in the
SECONDARY_CELL_MIMO_PARAMS variable;
1> otherwise:
2> if the IE "MIMO N_cqi_typeA/M_cqi ratio" is included:
3> store the value of the IE "MIMO N_cqi_typeA/M_cqi ratio" in the corresponding entry in the
SECONDARY_CELL_MIMO_PARAMS variable.
2> if the IE "MIMO pilot configuration" is included:
3> store the value of the IE "MIMO pilot configuration" in the corresponding entry in the
SECONDARY_CELL_MIMO_PARAMS variable.
2> if the IE "Precoding weight set restriction" is included in the IE "Secondary cell MIMO parameters":
3> store the value of the IE "Precoding weight set restriction" in the corresponding entry in the
SECONDARY_CELL_MIMO_PARAMS variable;
2> else if the IE "Precoding weight set restriction" is not included in the IE "Secondary cell MIMO parameters":
3> if the IE "MIMO operation" is included in the IE "MIMO parameters" and it is set to "start":
ETSI