ts_125331v120300p

3GPP TS 25.331 version 12.3.0 Release 12
446
ETSI TS 125 331 V12.3.0 (2014-10)
3> if System Information Block type 2 of the selected cell contains more than one URA identity, the list of
URA identities in system information block type 2 is empty or if the system information block type 2 can
not be found, a confirmation error of URA identity list has occurred:
4> if no URA update procedure is ongoing:
5> initiate a URA update procedure after entering URA_PCH state, see subclause 8.3.1.2.
4> if a URA update procedure is ongoing:
8.6.2.2 Mapping info
5> take actions as specified in subclause 8.3.1.10.
For FDD, 3.84 Mcps TDD and 7.68 Mcps TDD, if the IE "Mapping info" is received, the UE shall in this version of the
specification:
1> ignore the contents of this IE.
For 1.28 Mcps TDD, if the IE "Mapping info" is received, the UE shall:
1> if the IE "Map parameter 1" is included, interpret the IE "Map parameter 1" as IE "UpPCH Position Info":
2> store and use the UpPCH position indicated by the IE "UpPCH Positon Info". The calculation of the uplink
access position is described in [33].
1> if the IE "Map parameter 1" is not included:
2> use the UpPTS as the default UpPCH position.
1> ignore other contents of the IE "Mapping info".
8.6.2.3 RNC support for change of UE capability
The UE shall:
1> if the IE "RNC support for change of UE capability" is included in a received message:
2> set the variable RNC_CAPABILITY_CHANGE_SUPPORT to the value of the IE "RNC support for change
of UE capability".
8.6.2.4 CSG PSC Split Information
The UE shall:
1> if the IE "CSG PSC Split Information" is included in a received message:
2> consider the CSG PSC split information received on this cell to be valid for:
3> the UARFCN of the carrier on which it was received;
3> any cell not referenced in SIB18, or when SIB18 is not broadcast, while the cell the UE is camped on has
a PLMN which is the same as the PLMN of the cell where the CSG PSC split information was received;
3> any cell referenced in SIB18 that has the same PLMN as the PLMN of the cell in which the CSG PSC
split information was received;
3> while UE is not in Any Cell Selection state [4];
3> 24 hours from the time it was received.
NOTE 1: If the IE "CSG PSC Split Information" is received in both SIB3 and SIB11bis in the same cell then UE
behaviour is unspecified.
NOTE 2: The PLMN of a cell in the above paragraph is the PLMN in IE ‘PLMN identity’ of that cell.
ETSI