ts_125331v120300p

3GPP TS 25.331 version 12.3.0 Release 12
119
ETSI TS 125 331 V12.3.0 (2014-10)
3> perform the mapping of the Access Class to an Access Service Class as specified in subclause 8.5.13; and
3> apply the given Access Service Class when accessing the RACH or the common E-DCH (for the
Enhanced Uplink in CELL_FACH state and Idle mode);
3> submit a new RRC CONNECTION REQUEST message to lower layers for transmission on the uplink
CCCH;
3> increment counter V300;
3> restart timer T300 when the MAC layer indicates success or failure to transmit the message.
2> if V300 is greater than N300:
3> if the UE supports logging of failed RRC Connection Establishment, perform the actions specified in
subclause 8.1.3.11;
3> if the UE supports RRC Connection Establishment failure temporary Qoffset and RRC Connection
Establishment failure has occurred a consecutive "ConnEst Fail Count" times on the same cell for which
"Tx Fail Params" is included in System Information Block Type 3:
4> for a period as indicated by "Offset Validity":
5> use "ConnEst Fail Qoffset ,temp " for the parameter Qoffset temp for the concerned cell when
performing cell selection and reselection according to TS 25.304 [4] and TS 36.304 [66].
NOTE :
When performing cell selection, if no suitable or acceptable cell can be found, it is up to UE
implementation whether to stop using "ConnEst Fail Qoffset ,temp " for the parameter Qoffset temp during
"Offset Validity" for the concerned cell.
3> enter idle mode;
3> consider the procedure to be unsuccessful;
3> Other actions the UE shall perform when entering idle mode from connected mode are specified in
subclause 8.5.2;
3> the procedure ends.
8.1.3.5a
Abortion of RRC connection establishment
If the UE has not yet entered UTRA RRC Connected mode and the RRC connection establishment is to be aborted as
specified in subclause 8.1.8, the UE shall:
1> consider the procedure to be unsuccessful;
1> perform the actions when entering idle mode as specified in subclause 8.5.2.
The procedure ends.
8.1.3.6 Reception of an RRC CONNECTION SETUP message by the UE
The UE shall compare the value of the IE "Initial UE identity" in the received RRC CONNECTION SETUP message
with the value of the variable INITIAL_UE_IDENTITY.
If the values are different, the UE shall:
1> ignore the rest of the message.
If the values are identical, the UE shall:
2> if IE "Specification mode" is set to "Preconfiguration" and IE "Preconfiguration mode" is set to "Predefined
configuration":
3> initiate the radio bearer and transport channel configuration in accordance with the predefined parameters
identified by the IE "Predefined configuration identity" with the following exception;
ETSI