ts_125331v120300p

3GPP TS 25.331 version 12.3.0 Release 12
221
ETSI TS 125 331 V12.3.0 (2014-10)
In 1.28 Mcps TDD, if the IE "Uplink DPCH Power Control Info" and IE "PRX HS-SICH " and IE "TPC step size" are
transmitted, this information shall be taken into account by the UE for uplink open loop power control and for uplink
closed loop power control as described in subclause 8.6.6.11, and the"PRX HS-SICH " shall be taken into account by the UE
for open loop power control as described in subclause 8.5.7 and the "TPC step size" for closed loop power control on
HS-SICH.
In 3.84 Mcps TDD or 7.68 Mcps TDD, if the IEs "Uplink DPCH Power Control Info", "PRACH Constant Value",
"PUSCH Constant Value", "HS-SICH Power Control Info", "Alpha" or IE group "list of UL Timeslot Interference" are
transmitted, this information shall be taken into account by the UE for uplink open loop power control as specified in
subclause 8.5.7. If the UE is capable of using IPDLs for UE positioning, the IE "IPDL-Alpha" shall be used instead of
the IE "Alpha". If the IE "IPDL-Alpha" parameter is not present, the UE shall use IE "Alpha".
If the IE Special Burst Scheduling is transmitted the UE shall:
1> use the new value for the "Special Burst Generation Period".
The UE shall:
1> clear the entry for the UPLINK PHYSICAL CHANNEL CONTROL message in the table "Accepted
transactions" in the variable TRANSACTIONS;
1> and the procedure ends.
8.2.10.4 Invalid UPLINK PHYSICAL CHANNEL CONTROL message
If the UE receives a UPLINK PHYSICAL CHANNEL CONTROL message, which contains a protocol error causing
the variable PROTOCOL_ERROR_REJECT to be set to TRUE according to clause 9, the UE shall perform procedure
specific error handling as follows. The UE shall:
1> transmit an RRC STATUS message on the uplink DCCH using AM RLC, setting the information elements as
specified below:
2> include the IE "Identification of received message"; and
2> set the IE "Received message type" to UPLINK PHYSICAL CHANNEL CONTROL; and
2> set the IE "RRC transaction identifier" to the value of "RRC transaction identifier" in the entry for the
UPLINK PHYSICAL CHANNEL CONTROL message in the table "Rejected transactions" in the variable
TRANSACTIONS; and
2> clear that entry;
2> include the IE "Protocol error information" with contents set to the value of the variable
PROTOCOL_ERROR_INFORMATION.
1> when the RRC STATUS message has been submitted to lower layers for transmission:
2> continue with any ongoing processes and procedures as if the invalid UPLINK PHYSICAL CHANNEL
CONTROL message has not been received.
8.2.11 Physical channel reconfiguration failure
UE
UTRAN
PHYSICAL CHANNEL
RECONFIGURATION FAILURE
Figure 8.2.11-1: Physical channel reconfiguration failure in case of runtime configuration error
ETSI