28.11.2014 Views

ts_125331v120300p

ts_125331v120300p

ts_125331v120300p

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

3GPP TS 25.331 version 12.3.0 Release 12<br />

423<br />

ETSI TS 125 331 V12.3.0 (2014-10)<br />

1> clear any stored IE "Multi-carrier E-DCH Info for LCR TDD";<br />

If all of the above conditions are met and the variable MULTI_CARRIER_ E_DCH_TRANSMISSION is set to<br />

FALSE, the UE shall:<br />

1> set the variable MULTI_CARRIER_ E_DCH_TRANSMISSION to TRUE;<br />

1> reset the MAC-i/is entity [15].<br />

Whenever the variable MULTI_CARRIER_ E_DCH_TRANSMISSION is set to TRUE, the UE shall:<br />

1> perform E-AGCH reception procedures on the additional E-DCH carrier according to the stored IE "Multicarrier<br />

E-DCH Info for LCR TDD";<br />

1> perform E-HICH reception procedures on the additional E-DCH carrier according to the stored IE "Multi-carrier<br />

E-DCH Info for LCR TDD";<br />

1> perform uplink E-PUCH transmission on the additional E-DCH carrier according to the stored IE "Multi-carrier<br />

E-DCH Info for LCR TDD";<br />

1> inclusion of MAC-d PDU's in a MAC-i PDU for logical channels on the additional E-DCH carrier shall:<br />

2> be performed in accordance with the received scheduling grant on E-AGCH (see [15]) on the additional E-<br />

DCH carrier;<br />

Whenever the variable MULTI_CARRIER_ E_DCH_TRANSMISSION is set to FALSE, the UE shall:<br />

1> not perform E-AGCH, E-HICH reception procedures on any additional E-DCH carrier;<br />

1> not perform E-PUCH transmission procedures on any additional E-DCH carrier.<br />

8.5.63 Logged Measuremen<strong>ts</strong> Configuration<br />

8.5.63.1 General<br />

UE<br />

UTRAN<br />

LOGGING MEASUREMENT CONFIGURATION<br />

Figure 8.5.63.1-1: Logged measuremen<strong>ts</strong> configuration<br />

The purpose of this procedure is to configure the UE to perform logging of measurement resul<strong>ts</strong> while in IDLE mode<br />

CELL_PCH and URA_PCH states.<br />

NOTE:<br />

UTRAN may retrieve stored logged measurement information by means of the UE Information<br />

procedure.<br />

8.5.63.2 Initiation<br />

UTRAN initiates the logged measuremen<strong>ts</strong> configuration procedure to the UE by sending the LOGGING<br />

MEASUREMENT CONFIGURATION message.<br />

8.5.63.3 Reception of LOGGING MEASUREMENT CONFIGURATION by the UE<br />

Upon receiving the LOGGING MEASUREMENT CONFIGURATION message the UE shall:<br />

ETSI

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!