ts_125331v120300p

3GPP TS 25.331 version 12.3.0 Release 12
333
ETSI TS 125 331 V12.3.0 (2014-10)
1> else:
2> stop monitoring the list of E-UTRA frequencies assigned in the IE "E-UTRA frequency and priority info list"
in System Information Block type 19;
1> for FDD, if variable HS_DSCH_RECEPTION_CELL_FACH_STATE is set to TRUE and the variable
HS_DSCH_DRX_CELL_FACH_STATUS is set to TRUE:
2> perform measurements on other systems according to the requirements in [19], during the frame(s) with the
SFN value not fulfiling the inequality specified in subclause 8.5.49.
1> for FDD, if variable HS_DSCH_RECEPTION_CELL_FACH_STATE is set to TRUE and the variable
HS_DSCH_DRX_CELL_FACH_2CYCLE_STATUS is set to TRUE:
2> perform measurements on other systems according to the requirements in [19], during the frame(s) with the
SFN value not fulfiling the inequality specified in subclause 8.5.49b.
1> otherwise:
2> perform measurements on other systems, according to the IE "FACH measurement occasion info", as
specified in subclause 8.5.11.
1> for TDD:
2> perform measurements on other frequencies according to the IE "FACH measurement occasion info".
8.4.1.9.4 Traffic volume measurement
Upon transition from idle mode to CELL_FACH state, the UE shall:
1> store the measurement control information from the IE "Traffic volume measurement system information"
received in System Information Block type 12 (or System Information Block type 11, according to subclause
8.1.1.6.11) in the variable MEASUREMENT_IDENTITY;
1> begin traffic volume measurement reporting according to the assigned information.
8.4.1.9.5 UE positioning measurement
Upon transition from idle mode to CELL_FACH state, the UE may:
1> begin or continue monitoring assistance data received in System Information Block type 15 or System
Information Block type 15.1 or System Information Block type 15.2 or System Information Block type 15.3 or
System Information Block type 15.4 or System Information Block type 15.5 or System Information Block type
15bis or System Information Block type 15.1bis or System Information Block type 15.1ter or System
Information Block type 15.2bis or System Information Block type 15.2ter or System Information Block type
15.3bis or System Information Block type 15.6 or System Information Block type 15.7 or System Information
Block type 15.8 according to subclause 8.1.1.6.15;
1> if the IE "UE positioning OTDOA neighbour cell list for UE assisted" stored in the variable
UE_POSITIONING_OTDOA_DATA_UE_ASSISTED; or
1> if the IE "UE positioning OTDOA neighbour cell list for UE based" stored in the variable
UE_POSITIONING_OTDOA_DATA_UE_BASED contains neighbour cells on other frequencies than the
current frequency:
2> perform measurements on other frequencies according to the IE "FACH measurement occasion info".
8.4.1.9a
Measurements after transition from connected mode to idle mode
Upon transition from connected mode to idle mode the UE shall:
1> stop measurement reporting for all measurements stored in the variable MEASUREMENT_IDENTITY;
1> clear the variable MEASUREMENT_IDENTITY;
ETSI