ts_125331v120300p

3GPP TS 25.331 version 12.3.0 Release 12
535
ETSI TS 125 331 V12.3.0 (2014-10)
8.6.6.46 Control Channel DRX information (1.28 Mcps TDD only)
If the IE "Control Channel DRX information" is included and the UE will be in CELL_DCH state after completion of
this procedure, the UE shall:
1> if the CHOICE "Control Channel DRX operation" is set to "New Control Channel DRX operation":
2> store the contents of the IE in the variable CONTROL_CHANNEL_DRX_PARAMS, replacing or clearing
any previously stored "Control Channel DRX operation";
2> use the newly received Control Channel DRX configuration.
2> if the IE "E-AGCH DRX Information" is not included:
3> not perform E-AGCH discontinuous reception.
1> if the CHOICE "Control Channel DRX operation" is set to "Continue", and the message is used to perform a
hard handover (as specified in subclause 8.6.6.3a):
2> the UE behaviour is unspecified.
1> determine the value for the CONTROL_CHANNEL_DRX_STATUS variable and take the corresponding
actions as described in subclause 8.5.53.
1> if the IE "E-AGCH DRX Information" is included, and the variable E_DCH_TRANSMISSION is set to FALSE:
2> the UE behaviour is unspecified.
8.6.6.47 SPS information (1.28 Mcps TDD only)
If the IE "SPS information" is included and the UE will be in CELL_DCH state after completion of this procedure, the
UE shall:
1> if the IE "E-DCH SPS Information" is included and the UE will be in CELL_DCH state after completion of this
procedure, the UE shall:
2> if the CHOICE "E-DCH SPS operation" is set to "New E-DCH SPS operation":
3> after the UE has received IE "E-HICH Information":
4> if the CHOICE "Configuration Mode" is set to "Implicit":
5> if the IE "EI" is included:
6> consider the E-HICH has the same configuration as that in the IE "E-HICH Info" for 1.28Mcps
TDD which has the same value of EI indicated by the IE "EI" in this message.
5> else:
4> else:
6> use the same configuration as the E-HICH for non-schedule transmission.
5> store the E-HICH configuration according to the IEs "Timeslot Number", "Channelisation Code"
and midamble configuration IEs.
4> store and use the Signature Sequence indicated by the IE "Signature Sequence Group Index".
3> if the IE "Transmission Pattern List" is included:
4> store the contents of the IE in the variable E_DCH_SPS_PARAMS.
3> if the IE "Initial SPS info for E-DCH" is included:
4> perform E-DCH SPS operation on the semi-persistent E-PUCH resource configured by the IE at the
CFN determined by the IE "Activation Time" and the IE "Subframe number".
ETSI