FONIX® 8000 - Frye Electronics
FONIX® 8000 - Frye Electronics
FONIX® 8000 - Frye Electronics
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Introduction and Setup 19<br />
Speaker<br />
Probe Microphone 2nd Probe Microphone<br />
T630 mAL<br />
ELECTRICAL RATING:<br />
100–240 V~<br />
50-60 Hz .6A<br />
ATTENTION: For service refer to qualified personnel<br />
only. Consult accompanying documents.<br />
FONIX <strong>8000</strong> Serial No. 1234<br />
FONIX ®<br />
<strong>8000</strong><br />
HEARING AID TEST SYSTEM<br />
ELECTRONICS MODULE<br />
Made in Tigard, Oregon, USA<br />
By <strong>Frye</strong> <strong>Electronics</strong>, Inc.<br />
FRYE<br />
<strong>Frye</strong> <strong>Electronics</strong> products are protected by U.S.<br />
and/or foreign patents and/or patents pending<br />
Figure 1.6.4 —<strong>8000</strong> Real-ear setup<br />
1.6.5 Powering up the <strong>8000</strong> test system<br />
MIC<br />
LEFT<br />
FRYE<br />
KEYBD<br />
Earphone<br />
Probe Remote Module<br />
MIC<br />
RIGHT<br />
LINE<br />
INPUT<br />
SPKR B<br />
SPKR A MONITOR<br />
MIC<br />
INPUT<br />
POWER<br />
VOLUME<br />
MODULE 2 MODULE 1<br />
Probe Remote Module (Back Panel)<br />
EARPHONE<br />
RS232<br />
TO MAIN MODULE<br />
KEYBOARD<br />
COMPUTER<br />
Monitor Headset<br />
1. Turn on the <strong>8000</strong> system by reaching back on the right side of the main<br />
module (while you are facing the front of the unit), and pressing the POWER<br />
switch. The green LED on the front panel, above the words “POWER”, will<br />
turn on after a couple seconds.<br />
2. Turn on the video monitor. (Refer to the monitor’s manual for instructions, if<br />
necessary.)<br />
The Opening screen of the <strong>8000</strong> test system will be displayed. It contains the<br />
FONIX logo, along with the software version, the serial number, and the available<br />
options. This information is important in identifying your equipment when<br />
you communicate with the company about your FONIX <strong>8000</strong> test system.<br />
Note: Do not disconnect or connect the sound chamber or probe module when<br />
the analyzer is turned on. This will not damage the analyzer but it may have<br />
trouble detecting the chamber without a power cycle.<br />
VGA
Change language