HP ProCurve Wireless Access Point 420 - Hewlett Packard
HP ProCurve Wireless Access Point 420 - Hewlett Packard
HP ProCurve Wireless Access Point 420 - Hewlett Packard
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Access</strong> <strong>Point</strong> Configuration<br />
Configuring <strong>Wireless</strong> Security<br />
5-50<br />
8. Click the [Apply Changes] button.<br />
9. Click the [Authentication] button.<br />
10. Under 802.1x Setup, select Required.<br />
11. If there are clients in the service area that are not WPA-enabled, enter time<br />
periods for refreshing the session and broadcast encryption keys, and for<br />
re-authenticating the client.<br />
12. Click the [Apply Changes] button.<br />
13. Click the [WPA Settings] button.<br />
14. Under WPA Configuration Mode, check Required if you want only WPAenabled<br />
clients to connect to the network. If you want some clients to<br />
connect that are not WPA-enabled, leave this check box clear.<br />
15. Under Multicast Cipher Mode, select WEP if you are supporting any clients<br />
that are not WPA-enabled, otherwise select TKIP. Only select AES if you<br />
are sure that all clients support AES encryption.<br />
16. Click the [Apply Changes] button.<br />
To Configure WPA in Pre-shared Key Mode:<br />
1. Select the Security tab.<br />
2. Click the [Shared Key Setup] button.<br />
3. Set the Authentication Type Setup to Open System.<br />
4. Click the [Apply Changes] button.<br />
5. Click the [Authentication] button.<br />
6. Under 802.1x Setup, select Disable.<br />
7. Click the [Apply Changes] button.<br />
8. Click the [WPA Settings] button.<br />
9. Under WPA Configuration Mode, check Required.<br />
10. Under WPA Pre-Shared Key Type, select Hexadecimal or Alphanumeric.<br />
11. For the WPA Pre-Shared Key, enter exactly 64 hexadecimal digits or<br />
between 8 and 63 alphanumeric characters. (Be sure that all wireless<br />
clients use the same pre-shared key.)<br />
12. Click the [Apply Changes] button.