HP ProCurve Wireless Access Point 420 - Hewlett Packard

Getting Started
Sources for More Information
Sources for More Information
■ If you need information on specific features in the HP Web Browser
Interface (hereafter referred to as the “web browser interface”), use
the online help available for the web browser interface. For more
information on web browser Help options, refer to “Online Help for
the HP Web Browser Interface” on page 4-16.
■ If you need further information on Hewlett-Packard access point
technology, visit the HP ProCurve website at:
http://www.hp.com/go/hpprocurve
Need Only a Quick Start?
IP Addressing. If you just want to give the access point an IP address so that
it can communicate on your network, HP recommends that you use the CLI
to quickly configure IP addressing. To do so, do one of the following:
■ Enter config at the CLI Exec level prompt.
HP420#config
■ Enter interface ethernet at the CLI Configuration level prompt.
HP420(config)#interface ethernet
■ Enter the IP address, subnet mask, and gateway at the CLI Interface
Configuration level prompt.
HP420(if-ethernet)#ip address
For more on using the CLI, see Chapter 6, “Using the Command Line Interface
(CLI)”.
To Set Up and Install the Access Point in Your Network
Im portant! Use the Installation and Getting Started Guide shipped with your access
point for the following:
1-6
■ Notes, cautions, and warnings related to installing and using the
access point
■ Instructions for physically installing the access point in your network