HP ProCurve Wireless Access Point 420 - Hewlett Packard

Command Line Reference
Interface Commands
6-52
Command Function Mode Page
rts-threshold Sets the packet size threshold at which an RTS IC-W 6-65
must be sent to the receiving station prior to the
sending station starting communications
authentication Defines the 802.11 authentication type allowed IC-W 6-66
by the access point
encryption Defines whether or not WEP encryption is used IC-W 6-67
to provide privacy for wireless
communications
key Sets the keys used for WEP encryption IC-W 6-68
transmit-key Sets the index of the key to be used for IC-W 6-69
encrypting data frames sent between the
access point and wireless clients
transmit-power Adjusts the power of the radio signals IC-W 6-70
transmitted from the access point
max-association Configures the maximum number of clients that IC-W 6-70
can be associated with the access point at the
same time
multicast-cipher Defines the cipher algorithm used for IC-W 6-71
multicasting
wpa-clients Defines whether WPA is required or optionally IC-W 6-72
supported for client stations
wpa-mode Specifies dynamic keys or a pre-shared key IC-W 6-73
wpa-preshared-key Defines a WPA pre-shared key value IC-W 6-74
wpa-psk-type Defines the type of the pre-shared key IC-W ???
shutdown Disables the wireless interface IC-W 6-75
show interface Shows the status for the wireless interface Exec 6-75
wireless g
show station Shows the wireless clients associated with the Exec 6-77
access point