HP ProCurve Wireless Access Point 420 - Hewlett Packard

Access Point Configuration
Setting up Filter Control
5-34
To Enable VLAN Support:
1. Select the Security tab.
2. Click the [Shared Key Setup] button.
3. Set the Authentication Type Setup to Open System.
4. Click the [Apply Changes] button.
5. Click the [Authentication] button.
6. Under 802.1x Setup, select Required.
7. Click the [Apply Changes] button.
8. Select the Configuration tab.
9. Click the [Radius] button.
10. Configure parameters for the primary RADIUS server and, optionally, a
secondary RADIUS server. See “Web: Setting RADIUS Server Parameters”
on page 5-28 for more details.
11. Click the [Apply Changes] button.
12. Click the [Filter Control] button.
13. Type a number between 1 and 64 in the Native VLAN ID text field.
14. Set VLAN to enable.
15. Click the [Apply Changes] button.
To Set Local and Management Filters:
1. Select the Configuration tab.
2. Click the [Filter Control] button.
3. To prevent wireless-to-wireless client communication, set Local Bridge
Filter to enable.
4. To prevent access point management from wireless clients, set AP
Management Filter to enable.
5. To implement specific Ethernet protocol filters, set Ethernet Type Filter to
enable.
a. From the list of protocol types, select ON for those protocols that you
want to filter from the access point.
6. Click the [Apply Changes] button.
7. Reboot the access point by using the [Reboot] button from the Software
Upgrade screen on the Administration tab.