HP ProCurve Wireless Access Point 420 - Hewlett Packard

Access Point Configuration
Configuring Wireless Security
5-64
Command Syntax CLI Reference Page
[no] key page 6-68
transmit-key page 6-69
show interface wireless g page 6-75
The following example shows how to set up WEP shared keys that are used
for client authentication and data encryption.
To enhance security when using WEP, the CLI enables you to set the access
point as a closed system. When set as a closed system, the access point does
not include its SSID in beacon messages and does not respond to any probe
requests from clients that do not include the access point’s configured SSID.
HP420(config)#interface wireless g
Enter Wireless configuration commands, one per line.
HP420(if-wireless g)#authentication shared
HP420(if-wireless g)#closed-system
HP420(if-wireless g)#encryption 128
You changed the WEP key length, please make sure you change
your key for static WEP
HP420(if-wireless g)#key 1 128 ascii asdeipadjsipd
HP420(if-wireless g)#key 2 128 ascii lkdhenoekmpet
HP420(if-wireless g)#key 3 128 ascii zbxhwofpwutny
HP420(if-wireless g)#transmit-key 2
HP420(if-wireless g)#