HP ProCurve Wireless Access Point 420 - Hewlett Packard

Command Line Reference
System Management Commands
6-20
sntp-server enable
This command enables SNTP client requests for time synchronization with
NTP or SNTP time servers specified by the sntp-server ip command. Use the
no form to disable SNTP client requests.
Syntax
sntp-server enable
no sntp-server enable
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
The time acquired from time servers is used to record accurate dates and
times for log events. Without SNTP, the access point only records the time
starting from the factory default set at the last bootup (i.e., 00:14:00,
January 1, 1970).
Example
HP420(config)#sntp-server enable
HP420(config)#
Related Commands
sntp-server ip (page 6-19)
show sntp (page 6-23)
sntp-server date-time
This command sets the system clock.
Default Setting
00:14:00, January 1, 1970
Command Mode
Global Configuration