HP ProCurve Wireless Access Point 420 - Hewlett Packard
HP ProCurve Wireless Access Point 420 - Hewlett Packard
HP ProCurve Wireless Access Point 420 - Hewlett Packard
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
ping<br />
Command Line Reference<br />
General Commands<br />
This command sends ICMP echo request packets to another node on the<br />
network.<br />
Syntax<br />
ping <br />
• host_name - Alias of the host.<br />
• ip_address - IP address of the host.<br />
Default Setting<br />
None<br />
Command Mode<br />
Exec<br />
Command Usage<br />
• Use the ping command to see if another site on the network can be<br />
reached.<br />
• The following are some results of the ping command:<br />
– Normal response - The normal response occurs in one to ten<br />
seconds, depending on network traffic.<br />
– Destination does not respond - If the host does not respond, a<br />
“timeout” appears in ten seconds.<br />
– Destination unreachable - The gateway for this destination indicates<br />
that the destination is unreachable.<br />
– Network or host unreachable - The gateway found no corresponding<br />
entry in the route table.<br />
• Press [Esc] to stop pinging.<br />
Example<br />
<strong>HP</strong><strong>420</strong>#ping 10.1.0.9<br />
10.1.0.9 is alive<br />
<strong>HP</strong><strong>420</strong>#<br />
6-5
Change language