HP ProCurve Wireless Access Point 420 - Hewlett Packard

Command Line Reference
System Management Commands
6-8
System Management Commands
These commands are used to configure the user name, password, system logs,
browser management options, clock settings, and a variety of other system
information.
Command Function Mode Page
Country Setting
country
Device
Designation
prompt
system name
snmp-server
contact
snmp-server
location
User Access
username
password
Web Server
ip http port
ip http server
Event Logging
logging on
logging host
logging
console
Sets the country code for correct radio operation
Sets the access point country code Exec 6-9
Configures information that uniquely identifies this
device
Customizes the command line prompt GC 6-11
Specifies the host name for the access point GC 6-12
Sets the system contact string GC 6-26
Sets the system location string GC 6-29
Configures the user name and password for
management access
Configures the user name for management access GC 6-12
Specifies the password for management access GC 6-13
Enables management access via a Web browser
Specifies the port to be used by the Web browser GC 6-13
interface
Allows the access point to be monitored or configured GC 6-14
from a browser
Controls logging of error messages
Controls logging of error messages GC 6-15
Adds a syslog server host IP address that will receive GC 6-15
logging messages
Initiates logging of error messages to the console GC 6-16
logging level Defines the minimum severity level for event logging GC 6-16