HP ProCurve Wireless Access Point 420 - Hewlett Packard

Command Line Reference
Overview
6-2
Overview
This chapter describes the commands provided by the CLI.
The CLI commands can be broken down into the functional groups shown
below.
Command Group Description Page
General Basic commands for entering configuration mode, restarting
the system, or quitting the CLI
System
Management
Controls user name, password, system logs, browser
management options, clock settings, and a variety of other
system information
SNMP Configures community access strings and trap managers 6-25
Flash/File Manages code image or access point configuration files 6-30
RADIUS Configures the RADIUS client used with 802.1x authentication 6-34
Authentication Configures IEEE 802.1x port access control and address filtering 6-39
Filtering Filters communications between wireless clients, controls 6-47
access to the management interface from wireless clients, and
filters traffic using specific Ethernet protocol types
Interface Configures connection parameters for the Ethernet interface
and wireless interface
IAPP Enables roaming between multi-vendor access points 6-77
VLANs Configures VLAN membership 6-78
The access mode shown in the following tables is indicated by these abbreviations:
GC (Global Configuration), and IC (Interface Configuration).
6-3
6-8
6-51