HP ProCurve Wireless Access Point 420 - Hewlett Packard

Interface Commands
Command Line Reference
Interface Commands
The commands described in this section configure connection parameters for
the Ethernet interface and wireless interface.
Command Function Mode Page
General Interface
interface
Ethernet Interface
dns primary-server
dns secondary-server
ip address
ip dhcp
shutdown
speed-duplex
show interface ethernet
Wireless Interface
radio-mode
description
closed-system
speed
channel
ssid
beacon-interval
dtim-period
fragmentation-length
Enters specified interface configuration mode GC 6-53
Specifies the primary name server IC-E 6-53
Specifies the secondary name server IC-E 6-53
Sets the IP address for the Ethernet interface IC-E 6-54
Submits a DHCP request for an IP address IC-E 6-55
Disables the Ethernet interface IC-E 6-56
Configures speed and duplex operation IC-E 6-57
Shows the status for the Ethernet interface Exec 6-57
Sets the radio working mode IC-W 6-58
Adds a description to the wireless interface IC-W 6-59
Closes access to clients without a pre- IC-W 6-59
configured SSID
Configures the maximum data rate at which a IC-W 6-60
station can connect to the access point
Configures the radio channel IC-W 6-61
Configures the service set identifier IC-W 6-62
Configures the rate at which beacon signals IC-W 6-62
are transmitted from the access point
Configures the rate at which stations in sleep IC-W 6-63
mode must wake up to receive broadcast/
multicast transmissions
Configures the minimum packet size that can IC-W 6-64
be fragmented
6-51