HP ProCurve Wireless Access Point 420 - Hewlett Packard
HP ProCurve Wireless Access Point 420 - Hewlett Packard
HP ProCurve Wireless Access Point 420 - Hewlett Packard
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Command Line Reference<br />
Interface Commands<br />
6-58<br />
Command Mode<br />
Exec<br />
Example<br />
<strong>HP</strong><strong>420</strong>#show interface ethernet<br />
Ethernet Interface Information<br />
========================================<br />
IP Address : 192.168.1.1<br />
Subnet Mask : 255.255.255.0<br />
Default Gateway : 192.168.1.253<br />
Primary DNS : 192.168.1.55<br />
Secondary DNS : 10.1.0.55<br />
Speed-duplex : 100Base-TX Half Duplex<br />
Admin status : Up<br />
Operational status : Up<br />
========================================<br />
<strong>HP</strong><strong>420</strong>#<br />
radio-mode<br />
This command sets the working mode for the wireless interface.<br />
Syntax<br />
radio-mode <br />
• b - b-only mode: Both 802.11b and 802.11g clients can communicate<br />
with the access point, but 802.11g clients can only transfer data at<br />
802.11b standard rates (up to 11 Mbps).<br />
• g - g-only mode: Only 802.11g clients can communicate with the access<br />
point.<br />
• b+g - b & g mixed mode: Both 802.11b and 802.11g clients can communicate<br />
with the access point.<br />
Default Setting<br />
b & g mixed mode<br />
Command Mode<br />
Interface Configuration (<strong>Wireless</strong>)<br />
Example<br />
<strong>HP</strong><strong>420</strong>(if-wireless g)#radio-mode g<br />
<strong>HP</strong><strong>420</strong>(if-wireless g)#
Change language