HP ProCurve Wireless Access Point 420 - Hewlett Packard

address filter default
Command Line Reference
802.1x Port Authentication
This command sets filtering to allow or deny listed MAC addresses.
Syntax
address filter default
Default
• allowed - Only MAC addresses entered as “denied” in the address
filtering table are denied.
• denied - Only MAC addresses entered as “allowed” in the address
filtering table are allowed.
allowed
Command Mode
Global Configuration
Example
HP420(config)#address filter default denied
HP420(config)#
Related Commands
address filter entry (page 6-43)
show authentication (page 6-46)
address filter entry
This command enters a MAC address in the filter table.
Syntax
address filter entry
Default
• mac-address - Physical address of client. Enter six pairs of hexadecimal
digits separated by hyphens, e.g., 00-90-D1-12-AB-89.
• allowed - Entry is allowed access.
• denied - Entry is denied access.
None
6-43