HP ProCurve Wireless Access Point 420 - Hewlett Packard

Command Line Reference
Interface Commands
6-62
ssid
This command configures the Service Set IDentifier (SSID).
Syntax
ssid
string - The name of a basic service set supported by the access point.
(Range: 1 - 32 characters)
Default Setting
Enterprise Wireless AP
Command Mode
Interface Configuration (Wireless)
Command Usage
Clients that want to connect to the network via the access point must set
their SSIDs to the same as that of the access point.
Example
HP420(if-wireless g)#ssid RD-AP#3
HP420(if-wireless g)#
beacon-interval
This command configures the rate at which beacon signals are transmitted
from the access point.
Syntax
beacon-interval
interval - The rate for transmitting beacon signals.
(Range: 20-1000 milliseconds)
Default Setting
100
Command Mode
Interface Configuration (Wireless)