HP ProCurve Wireless Access Point 420 - Hewlett Packard

Filtering Commands
Command Line Reference
Filtering Commands
The commands described in this section are used to filter communications
between wireless clients, control access to the management interface from
wireless clients, and filter traffic using specific Ethernet protocol types.
Command Function Mode Page
filter local-bridge
filter ap-manage
filter ethernet-type
enable
filter ethernet-type
protocol
show filters
filter local-bridge
Disables communication between wireless clients GC 6-47
Prevents wireless clients from accessing the GC 6-48
management interface
Checks the Ethernet type for all incoming and outgoing GC 6-48
Ethernet packets against the protocol filtering table
Sets a filter for a specific Ethernet type GC 6-49
Shows the filter configuration Exec 6-50
This command disables communication between wireless clients. Use the no
form to disable this filtering.
Syntax
filter local-bridge
no filter local-bridge
Default
Disabled
Command Mode
Global Configuration
Command Usage
This command can disable wireless-to-wireless communications between
clients via the access point. However, it does not affect communications
between wireless clients and the wired network.
6-47