HP ProCurve Wireless Access Point 420 - Hewlett Packard
HP ProCurve Wireless Access Point 420 - Hewlett Packard
HP ProCurve Wireless Access Point 420 - Hewlett Packard
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Command Line Reference<br />
System Management Commands<br />
Command Function Mode Page<br />
logging facilitytype<br />
Sets the facility type for remote logging of syslog<br />
messages<br />
GC 6-17<br />
show logging Displays the state of logging Exec 6-18<br />
System Clock Sets the system clock via an NTP/SNTP server<br />
sntp-server ip Specifies one or more time servers GC 6-19<br />
sntp-server Accepts time from the specified time servers GC 6-20<br />
enable<br />
sntp-server<br />
date-time<br />
sntp-server<br />
daylight-saving<br />
sntp-server<br />
timezone<br />
Manually sets the system date and time GC 6-20<br />
Sets the start and end dates for daylight savings time GC 6-21<br />
Sets the time zone for the access point’s internal clock GC 6-22<br />
show sntp Shows current SNTP configuration settings Exec 6-23<br />
System Status Displays system configuration and version information<br />
show system Displays system information Exec 6-23<br />
show version Displays version information for the system Exec 6-24<br />
country<br />
This command configures the access point’s Country Code, which identifies<br />
the country of operation and sets the correct authorized radio channels.<br />
This command is available only if you are using the worldwide product,<br />
J8131A.<br />
Syntax<br />
country <br />
country_code - A two character code that identifies the country of<br />
operation. See Table 6-1 on page 6-10 for a full list of the available<br />
codes.<br />
6-9
Change language