HP ProCurve Wireless Access Point 420 - Hewlett Packard
HP ProCurve Wireless Access Point 420 - Hewlett Packard
HP ProCurve Wireless Access Point 420 - Hewlett Packard
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Access</strong> <strong>Point</strong> Configuration<br />
Configuring Ethernet Interface Parameters<br />
The following example shows how to disable the Ethernet interface, force the<br />
setting to 100 Mbps full duplex, and then re-enable it.<br />
<strong>HP</strong><strong>420</strong>(config)#interface ethernet<br />
Enter Ethernet configuration commands, one per line.<br />
<strong>HP</strong><strong>420</strong>(if-ethernet)#shutdown<br />
<strong>HP</strong><strong>420</strong>(if-ethernet)#speed-duplex 100mf<br />
<strong>HP</strong><strong>420</strong>(if-ethernet)#no shutdown<br />
<strong>HP</strong><strong>420</strong>(if-ethernet)#<br />
To display the current Ethernet interface status from the Exec level, use the<br />
show interface ethernet command, as shown in the following example.<br />
<strong>HP</strong><strong>420</strong>#show interface ethernet<br />
Ethernet Interface Information<br />
===========================================================<br />
IP Address : 10.1.0.1<br />
Subnet Mask : 255.255.255.0<br />
Default Gateway : 0.0.0.0<br />
Primary DNS : 0.0.0.0<br />
Secondary DNS : 0.0.0.0<br />
Speed-duplex : 100Base-TX Full Duplex<br />
Admin status : Up<br />
Operational status : Up<br />
===========================================================<br />
<strong>HP</strong><strong>420</strong>#<br />
5-27