DCS User Manual EN.pdf

ED [DCS USER MANUAL]
If the SPEED or ETA value is outside of the valid range for the particular unit (such as
desired speed below the minimum flying speed), the SPEED and ETA fields change to
red font to indicate an invalid value warning and a corresponding message appears
when the user attempts to close the Group Properties Menu or save the mission. To
correct such an error, enter a valid value in the locked field.
If the user attempts to set an invalid route, for example lock the speed for all waypoints
and at the same time lock the ETA for the starting and final waypoints, the SPEED and
ETA checkboxes become framed in red to indicate a flag error warning and a
corresponding message appears when the user attempts to close the group properties
panel or save the mission:
To correct such an error, set waypoint locks to a valid route combination.
HINTS:
To avoid repetitive error messages when closing the group properties panel, use
the waypoint edit panel to cycle between waypoints rather than selecting
waypoints on the map:
117 DCS USER MANUAL